Snaggletooth 69 F350 Comes home.

[kid]

Blow by Blow plans.

Heads are now C8AE-Hs so I need to see what the specs are. If not good I am going to go after some older 352 or 406 heads.
427 Exhaust valves Manley Severe Duty Series Stainless Steel Valves
Valves, Exhaust, Stainless Steel, 1.750 in. Diameter, Ford, Big Block, FE, Set of 8
427 intake valves Manley Severe Duty Series Stainless Steel Valves
Valves, Intake, Stainless Steel, 2.250 in. Diameter, Ford, Big Block, FE, Set of 8

Roller Rockers with Hydraulic Power Beast Cam from Crower.
D3TE Block
Custom Crank and Rods from Crower.

I haven't decided whose pistons yet since with the special rod length the Piston pin placement has to move. I have had great luck in Drag racing FEs with Arias but in my Desert racers I used TRWs.

Zoom Clutch 11" , Overdrive in front of my NP435.

[kid]

This is why I cut the fenders off and ground the bolt heads off.








This is why I have to move it already. The garage is not big enough.

[oldbiker]

I can't believe what I am seeing in the very first picture!! when I went to Mesa to pick up Johns F-250 I spent 1/2 a day trying to rent a tow dolly like that from U-Haul I told them I had seen truck on them before, they told me that a bump was to wide and I was outta my mind I am gonna copy those pics and shove them up somebodies ...srry had to vent.............

[theskytoucher]

NO matter how much you fight it they still wont rent you rhe dolly. the way to get the dolly is tell them it is for a small car and they will send you on your way!!!

[oldbiker]

NO matter how much you fight it they still wont rent you rhe dolly. the way to get the dolly is tell them it is for a small car and they will send you on your way!!!

Yeah, I see that, but I now am the proud owner of a chincy tow bar I had to purchase when I got there. I had called made all the arrangements it was all good till I spent a small fortune in fuel to get there. ..I think I have had my last dealing w/U-Haul..I think I said that before and used Penske. Live & learn..sometimes Not gonna let those $@#$# ruin any more of my good nature

[390Nut]

My local machine shop say he has had great luck getting 360s with the backwards 105 on them to reach 4.25 bore.

You know where the 352 casting is by the water pump. Well some blocks have a 105 right there these were heavier cast blocks with thicker walls and higher nickel content. If i'm not mistaken i think they were cast in mexico in the 70's like 360's mainly?? I got a 75' 360 105 block along with my 250 when i bought it.

[FLATBEDFORD]

I thought you guys didn't have rust out west.