putting in new clutch

peanutman · Post by **peanutman** » Sat Aug 16, 2008 12:12 pm

Putting in new clutch kit, should i have fly wheel resurfaced shows little wear. And is a flywheel like a brake rotor, is there a possililty it can't be resurfaced if it has been once before

Also this is off of a 302. Are there marks that i need to line up with when it goes back on

peanutman · Post by **peanutman** » Sat Aug 16, 2008 1:57 pm

Thanks kap for the reply hopefully someone else will know about flywheel alignment on a 302.

69timemachine · Post by **69timemachine** » Sat Aug 16, 2008 7:50 pm

If I remember correctly, my 302 I used to have had the flywheel bolts slightly staggered to where the flywheel would only go on the crankshaft in one position.

unclejtl · Post by **unclejtl** » Sun Aug 17, 2008 11:49 am

If I remember correctly, my 302 I used to have had the flywheel bolts slightly staggered to where the flywheel would only go on the crankshaft in one position.

69Timemachine is correct, I just did mine.

The FORDification.com Forums

putting in new clutch

putting in new clutch

re: putting in new clutch

re: putting in new clutch