Hillbillydelux 69 Ranger
Moderator: FORDification
- basketcase0302
- 100% FORDified!
- Posts: 6805
- Joined: Thu Jan 26, 2006 7:11 am
- Location: Hawthorne, Florida
Re: Hillbillydelux 69 Ranger
HillBillyDelux,
I did find a couple of different throttle linkages here. And yesterday also found that my 79' dent gas pedal assembly is actually about one inch longer/taller in the engine compartment side. Here's a couple of pictures of the linkages that might help you. Both of the below measure about 10 and 1/2" long.
The homeade "extended" linkage from my 79' with a 302:
http://s240.photobucket.com/albums/ff13 ... g&newest=1
The 79' dentside offset linkage:
http://s240.photobucket.com/albums/ff13 ... g&newest=1
http://s240.photobucket.com/albums/ff13 ... g&newest=1
And a 460 cable linkage type intake manifold bracket:
http://s240.photobucket.com/albums/ff13 ... g&newest=1
http://s240.photobucket.com/albums/ff13 ... g&newest=1
I hope to use my dent pedal assembly, and find the cable and intake mount for my 302, (seems like I had one/can't seems to find it).
IMO the cable type is a lot more forgiving than mechanical type linkage. Especially if you have worn cab bushings like I do.
I did find a couple of different throttle linkages here. And yesterday also found that my 79' dent gas pedal assembly is actually about one inch longer/taller in the engine compartment side. Here's a couple of pictures of the linkages that might help you. Both of the below measure about 10 and 1/2" long.
The homeade "extended" linkage from my 79' with a 302:
http://s240.photobucket.com/albums/ff13 ... g&newest=1
The 79' dentside offset linkage:
http://s240.photobucket.com/albums/ff13 ... g&newest=1
http://s240.photobucket.com/albums/ff13 ... g&newest=1
And a 460 cable linkage type intake manifold bracket:
http://s240.photobucket.com/albums/ff13 ... g&newest=1
http://s240.photobucket.com/albums/ff13 ... g&newest=1
I hope to use my dent pedal assembly, and find the cable and intake mount for my 302, (seems like I had one/can't seems to find it).
IMO the cable type is a lot more forgiving than mechanical type linkage. Especially if you have worn cab bushings like I do.
Jeff
http://www.fordification.com/forum/view ... 22&t=46251
SOLD-71 F-350 dually flatbed, 302 / .030 over V-8 with a "baby"C-6, B & M truckshifter, Dana70/4.11 ratio, intermittent wipers, tilt steering, full LED lighting on the flat bed, and no stereo yet (this way I can hear the rattles to diagnose)! SOLD!
Many Ford bumps / one 76' EB / and several dents through the years.
A lot of "oddball" Ford parts collected from working on them for 34 years now!
2008 Ford Escape 4 x 4
http://www.fordification.com/forum/view ... 22&t=46251
SOLD-71 F-350 dually flatbed, 302 / .030 over V-8 with a "baby"C-6, B & M truckshifter, Dana70/4.11 ratio, intermittent wipers, tilt steering, full LED lighting on the flat bed, and no stereo yet (this way I can hear the rattles to diagnose)! SOLD!
Many Ford bumps / one 76' EB / and several dents through the years.
A lot of "oddball" Ford parts collected from working on them for 34 years now!
2008 Ford Escape 4 x 4
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
i took off the 1" carb spacer which allowed me to adjust my current linkage so i can now achieve both idle and WOT it runs a lot better and seems to have a tad better low end than with the spacer. It runs a lot better with the new intake and exhaust!! if i didnt know any better id think it was fast haha I think it still needs jetted down a tad tho
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
wont be long and Blueblue will be in the lowered thread!! i already did the half hanger flip on the back now i gotta cut some front coils!!
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
The plan its a photoshopped copy of the before
before
after
i think its pretty close to the plan even got the tips but u cant see em cuz the engine was runnin and its very cold out
edit: and i jus noticed my tag light isnt burnin so ill have to check my connections on it
before
after
i think its pretty close to the plan even got the tips but u cant see em cuz the engine was runnin and its very cold out
edit: and i jus noticed my tag light isnt burnin so ill have to check my connections on it
Last edited by HillbillyDelux on Fri Jan 08, 2010 7:07 pm, edited 1 time in total.
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
another for good measure. you can see the tips a little bit in this one
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
ok just one more its a fuzzy cell phone pic but it shows the stance pretty well.
i think im going to take another half a ring outta the front coils to get the nose down a bit more
i think im going to take another half a ring outta the front coils to get the nose down a bit more
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- 1967AceStroker
- Preferred User
- Posts: 319
- Joined: Sat Oct 11, 2008 1:01 pm
- Location: Pueblo, CO
Re: Hillbillydelux 69 Ranger
Looks good, makes me want to drop mine just a bit. How hard was that to do?
My Project Thread (Not updated in years.)
1967 F-100, Shortbed, 351W - 72mm Single Turbo - Megasquirt MS3x Engine Management, Tremec TKO 500, Ford 9" - Strange Nodular Center Section - Strange 35 Spline Axles - Strange Full Spool - Caltracs - DJM Drop Kit, Crown Vic IFS Swapped - 2 Coils Cut, Power Steering, Power 4 Wheel Disc Brakes, Paint - Kona Blue
1967 F-100, Shortbed, 351W - 72mm Single Turbo - Megasquirt MS3x Engine Management, Tremec TKO 500, Ford 9" - Strange Nodular Center Section - Strange 35 Spline Axles - Strange Full Spool - Caltracs - DJM Drop Kit, Crown Vic IFS Swapped - 2 Coils Cut, Power Steering, Power 4 Wheel Disc Brakes, Paint - Kona Blue
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
the front was a breeze but it was fairly difficult to get the rivets out of the rear. they grind down pretty easily but they're hard to knock out so you can get the bracket loose
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
-
- Blue Oval Guru
- Posts: 1080
- Joined: Sat Jul 04, 2009 9:13 am
- Location: Texas, Iowa Park
Re: Hillbillydelux 69 Ranger
Looking good. Keep the pics coming.
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
thanks. ill take some more and post em up as soon as i get it cleaned up. might even throw in a burnout video
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
my buddy cut this one short but u get the idea
http://s889.photobucket.com/albums/ac99 ... 0_3272.flv
X-PIPE!!!
http://s889.photobucket.com/albums/ac99 ... 0_3271.flv
<embed width="600" height="361" type="application/x-shockwave-flash" allowFullscreen="true" allowNetworking="all" wmode="transparent" src="http://static.photobucket.com/player.sw ... 0_3271.flv">[/video]
http://s889.photobucket.com/albums/ac99 ... 0_3272.flv
X-PIPE!!!
http://s889.photobucket.com/albums/ac99 ... 0_3271.flv
<embed width="600" height="361" type="application/x-shockwave-flash" allowFullscreen="true" allowNetworking="all" wmode="transparent" src="http://static.photobucket.com/player.sw ... 0_3271.flv">[/video]
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
-
- Blue Oval Guru
- Posts: 1080
- Joined: Sat Jul 04, 2009 9:13 am
- Location: Texas, Iowa Park
Re: Hillbillydelux 69 Ranger
You cant beat the X pipe sound.
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
you speak the truth. I love it
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- HillbillyDelux
- New Member
- Posts: 212
- Joined: Sun Jul 06, 2008 12:07 pm
- Location: Maiden, NC
Re: Hillbillydelux 69 Ranger
there are some more vids on my photobucket as well...open headers idle and rev, new exhaust idle and rev, and a couple in cab with open headers u gotta turn up the sound to really appreciate them haha
2000 Ford Ranger 4x4 "DD"
2003 Cobra
"If it ain't broke fix it til it is"
2003 Cobra
"If it ain't broke fix it til it is"
- Caseys71
- Blue Oval Guru
- Posts: 1289
- Joined: Sat Nov 07, 2009 7:48 pm
- Location: Hampstead, North Carolina
Re: Hillbillydelux 69 Ranger
, The X-pipe sounds wonderful , and I watched a few of your other videos, well listened to them .
Casey
16 years old with a 40 year old truck (well almost)
1971 F-100302, T-18 4 speed, 3:55 rear, & an Edelbrock sticker on the ashtray.
"Don't worry about what you become, just make sure that you're successful at what you do."- Mr. English
"Value what you DO have over that which you don't."- Forrestbump
"Wanting can sometimes be better than having, never stop dreaming... it's what keeps us all going."- Forrestbump
1984 Toyota 4x4: 22-R, 5-speed, 3" suspension lift, 35's and 5:29's
16 years old with a 40 year old truck (well almost)
1971 F-100302, T-18 4 speed, 3:55 rear, & an Edelbrock sticker on the ashtray.
"Don't worry about what you become, just make sure that you're successful at what you do."- Mr. English
"Value what you DO have over that which you don't."- Forrestbump
"Wanting can sometimes be better than having, never stop dreaming... it's what keeps us all going."- Forrestbump
1984 Toyota 4x4: 22-R, 5-speed, 3" suspension lift, 35's and 5:29's