Correct hub cap for 67 F250?

[WRX_Boy]

Thanks.

And sorry, I just realized I sort of hi-jacked this thread. At least it was a related hi-jacking.

[ezernut9mm]

here is the hubcap i was talking about off of a 67 f250 with 16.5 slit rims.

[Ks Highboy]

ezernut, thanks for posting that. I did not know they made a innie and outie that looked the same. I thought all innies were the style like at the bottom of the hub cap i.d. page and all the way to the right. Do the innies like the ones at the bottom fit a F250 with the Dana 60? Does it clear the axle?

[Ks Highboy]

http://www.fordification.com/tech/image ... d-F250.jpg I was told that this style was used on 67's as well as the style you posted. I found a set of these but I didn't know if they would clear the dana 60 axle.

[Ks Highboy]

http://www.fordification.com/tech/image ... d-F250.jpg I was told that this style was used on 67's as well as the style you posted. I found a set of these but I didn't know if they would clear the dana 60 axle.

[ezernut9mm]

mine has a d60, but my back wheels are the "outie"style so i haven't had them on. the one's you are talking about should clear the d60. i had a set on a 250 i had years ago. i think they are a real good looking hubcap in stainless.