DJM Dream Beam king pin receiver angle

[1bigogre]

I purchased DJM Dream Beam part number DB3004-3 for my 72 F100. When I attempted to identify the driver and passengers side beams I noticed that the king pin receiver tube on one is at a significantly different angle than the other. One seems to have more than a 5° inclination. Also the upright on one seems to be at a slightly different angle than the other. In the attached pictures you will see that I placed two straight dowels along side the beams and the king pins in the receiver to show the angle difference. Are they supposed to have that much of a difference due to which side of the truck they install? I am very hesitant to install these until I know they are correct. Thanks for your time.

[HIO Silver]

Compare.them to your OEM beams and report back.

[Canonman67]

Did you get it figured out?

[pedro69ford]

i had the same question when i bought mine,i called djm and they said it was normal,seems like they told me to make sure they point to the rear of the truck,if i remember correctly.