Fender mounting

[Blue_Streak]

I've finally started to put my 1967 truck back together for pre-paint fit and fitment and I came upon a bit of a problem. When installing the fenders to the rad support , there are 3 mounting holes. Without thinking I just assumed that they would be the same "c-clips" that are used on the top of the fender. However, now that I have gotten in to it, I see that because there is a small flange on the rad support edge , I can't use the c-clips. It looks like I can fit a c-clip on the bottom hole though.

What fasteners get used to hold the other two holes? A simple bolt and nut just doesn't seem right.

Thanks in advance

[cep62]

I'm can't picture it . Is it just a square hole?
If so those had a nut swedged into the hole, or a cage nut.
https://www.auveco.com/cage-nut-5-16-18 ... range-3798

If these don't sound right post a pic.

[Blue_Streak]

I'm can't picture it . Is it just a square hole?
If so those had a nut swedged into the hole, or a cage nut.
https://www.auveco.com/cage-nut-5-16-18 ... range-3798

If these don't sound right post a pic.

No. Its an oval hole. Someone directed me to the schematics and diagrams section and it looks like it it really is just a bolt and nut. I appreciate your input. Thank you

[cep62]

Maybe the clip is on the fender and the bolt comes from behind the rad support ?

[Fraser]

I would have to know the exact position of the fasteners in question, but I think there are special clips which are wider at the folded end. I cannot access my parts trucks for reference for a couple more weeks, still too muddy out there, but will look closer when I can.