Broke something...

[bigman78]

Ok, heres the story. Me and my dad went to pickup 4 units of fence board (dump trailer weighed in at 13,140). Anyways we load it up and head over to my uncles house. When we get there it needs to be in the backyard which means using the alley. Long story short he gets stuck. So the neighbors got an 80' something toyota, he comes over and hops around a bit. We decide to go get my truck So I go get it and hook up the PTO. It pulls him into the fence post. So I pull closer and hook up again and everything on the winch spins but the spool. So I broke a weld somewhere. So we hook up a chain and put it in 4low. As soon as I hit the gas I here something snap and my stick starts shaking side to side. It felt like the whole tranny was shaking badly. Anyways,I broke some kind of mount I think. Probably motor mount or tranny mount. Any ideas??

[fordman]

my first reaction is motor mount like you said or maybe bellhousing. i'm not sure on that though.

[ICEMAN6166]

i see you have a 429, did you use L&L mounts? sounds like one broke to me too, cant be sure but would cause a bunch of shaking.

[68F250]

The L&L mounts are prone to breaking.

[bigman78]

Im not sure what they are but it was raining and snowing all day so I didnt get a chance to look at it.

[heep70]

If not a mount then check the ring and pinion. They bust when pulling hard in reverse in a front D44. Probably not in your case, but its a thought for ya.